Nortel 2350 Installation And Basic Configuration Manual page 29

Table 3: WSS Status LEDs—2350 (continued)
LED Appearance
Link Solid green
(ports 1 and 2)
Solid amber
Blinking green
Blinking amber
Factory Reset Solid green
(port 1 only)
Blinking green
Unlit
AP (port 2 only) Solid green
Alternating green and
amber
Solid amber
Blinking amber
Unlit
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
WLAN—Security Switch Overview 29
Meaning
100-Mbps link is operational.
10-Mbps link is operational.
Traffic is active on the 100-Mbps link.
Traffic is active on the 10-Mbps link.
The switch is booting and is loading its
configuration file. This LED state lasts for
three seconds.
The switch is booting but the factory reset
switch is being pressed. The switch does not
load its configuration file but instead
contacts WLAN Management Software to
request a configuration.
This LED state lasts for three seconds.
The switch has finished booting.
For an AP access point's active link, with
PoE enabled, all the following are true:
• AP access point has booted.
• AP access point has received a valid
configuration from the WSS.
• Management link with an AP access
point is operational.
AP access point is booting with an image
received from the WSS.
If the LED remains in this state indefinitely,
the boot or configuration attempt has failed.
PoE is on but no AP access point is
connected to the link.
AP is not connected or is unresponsive, or
there is a PoE problem.
Port is not configured as an AP access port,
or PoE is off.