Configuration Commands - Nortel 2350 Installation And Basic Configuration Manual

146 Configuring a 2350 Switch for a Branch Office

Configuration Commands

To configure these parameters:
1
Access the enable (configuration) level of the CLI and configure an enable password:
2370> enable
2370# set enablepass
Enter old password: <CR>
Enter new password: configaccess
Retype new password: configaccess
success: password changed
2
Configure a username and password for administrative access through SSH or Telnet, and verify the
change:
2370# set user mxradmin password letmein
success: change accepted.
2370# show aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Radius Servers
Server
State
---------------------------------------------------------------
----
Server groups
user mxradmin
Password = 011f0310560e0f01 (encrypted)
3
Create an encryption key pair for SSH:
2370# crypto generate key ssh 1024
key pair generated
4
Add the uplink port to the default VLAN, configure an IP interface on the VLAN, and designate the
interface to be the 2350's system IP address. Then verify the changes.
2370# set vlan 1 port 1
success: change accepted.
2370# set interface 1 ip 10.10.20.15/24
success: change accepted.
2370# set system ip-address 10.10.20.15
This will cause all APs to reboot. Are you sure? (y/n) [n]y
success: change accepted.
320656-A
Addr Ports T/o Tries Dead