Installation Hardware And Tools; Installing A Wss - Nortel 2350 Installation And Basic Configuration Manual

42 Installing and Connecting a WLAN—Security Switch
1000BASETX Gigabit Ethernet Cable Wiring
Use Cat 5 Enhanced (Cat 5E) or better cable. 1000BASE-TX uses all 8 wires in the cable. The wiring can be
straight-through or crossover. The port automatically configures its pin signals accordingly.
Note.
PoE is not supported on 1000BASE-TX links. All wires in the cable are used for
data.

Installation Hardware and Tools

Caution!
that the mechanical load on the device is evenly distributed. For example, make sure the
switch is level in the equipment rack, is evenly fastened by screws on either side, and does
not have a heavy object resting on one side of the switch.
Table 7 lists the mounting hardware and tools required for each type of installation.
Table 7: Required Mounting Hardware and Tools
Mounting Option
Equipment rack
• Front-mount or
center-mount option for
the 2370 or 2380 switch
• Front-mount option for the
2360 switch
Tabletop
(applicable to all switch
models)

Installing a WSS

You can mount a WSS-2370, 2360, or 2380 switch in a standard 48.26-cm (19-inch) equipment rack or on a tabletop.
Each WSS is shipped with two brackets for rack mounting and four adhesive rubber feet for tabletop mounting. The
320656-A
To reduce the risk of equipment damage, make sure the WSS is installed so
Required Hardware and
Tools
Mounting brackets
Four rack-mount screws and
screwdriver
Note: Equipment racks vary, and the
screw and screwdriver type depend on
the equipment rack.
Power cords
Serial console cable
Four adhesive rubber feet
Power cord(s)
Serial console cable
Included with the
Product
Yes
No
Yes (one)
Yes
Yes
Yes
Yes