Nortel 2350 Installation And Basic Configuration Manual page 152

152 Configuring a 2350 Switch for a Branch Office
Radio 1: type: 802.11g, mode:
tx pwr: 15, profile: branch1_radprof
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode:
tx pwr: 11, profile: branch1_radprof
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
2370# show dap config
Dap 1: serial-id: 0123456789, AP model: 2330, bias: high, name: DMP01
fingerprint:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode:
tx pwr: 15, profile: branch1_radprof
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode:
tx pwr: 11, profile: branch1_radprof
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
16 Configure user group branch1_users and assign the group to the user VLAN, branch1_vlan. Then add
users to the branch1_users group and verify the changes:
2370# set usergroup branch1_users attr vlan-name branch1_vlan
success: change accepted.
2370# set user alice password alicepass
success: change accepted.
2370# set user alice group branch1_users
success: change accepted.
2370# set user bob password bobpass
success: change accepted.
2370# set user bob group branch1_users
success: change accepted.
2370# show aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Radius Servers
Server
State
---------------------------------------------------------------
----
Server groups
usergroup branch1_users
vlan-name = branch1_vlan
user mxradmin
320656-A
enabled, channel: dynamic
enabled, channel: dynamic
enabled, channel: dynamic
enabled, channel: dynamic
Addr Ports T/o Tries Dead