Nortel 2350 Installation And Basic Configuration Manual page 53

AP LED Appearance
Solid green
Alternating green and amber
Solid amber
Blinking amber
Unlit
3
If the cable is attached to a wired end station that uses AAA through the WSS to access the network:
●
For a first-time installation, set the port type to activate the link. (For information, see
a Port for a Wired Authentication User" on page
●
If the port type is already set for a wired authentication port, go on to
4
If the cable is directly attached to a device other than an AP access point:
a
Observe the appearance of the Link LED for the port:
Link LED Appearance
Solid green
Solid amber
Blinking green
Blinking amber
Unlit
b
If the Link LED is unlit, check the cable and verify that the device at the other end of the link is
operating.
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Installing and Connecting a WLAN—Security Switch 53
Meaning
For an AP access point's active link, with PoE
enabled, all the following are true:
• AP access point has booted.
• AP access point has received a valid
configuration from the WSS.
• Management link with an AP access point is
operational.
For an AP access point's secondary link, the link is
present.
AP access point is booting with an image received
from the WSS.
PoE is on, but no AP access point is connected to the
link.
AP access point is unresponsive or there is a PoE
problem.
PoE is off.
101.)
Meaning
100-Mbps link is operational.
10-Mbps link is operational.
Traffic is active on the 100-Mbps link.
Traffic is active on the 10-Mbps link.
Link is not operational.
"Configuring
step 4.