Nortel 2350 Installation And Basic Configuration Manual page 74

74 WSS Setup Methods
-----END CERTIFICATE-----
9
Save the configuration changes:
2361# save config
success: configuration saved.
Example 4: Deployment Site Has DHCP But Local DNS Domain Differs From
Corporate DNS Domain
The deployment site in this example has a DHCP server, so the switch's DHCP client is enabled. Static IP address and
default gateway information are not required. The site also has a local DNS server. However, the local DNS domain
name is different from the corporate DNS domain name where WLAN Management Software Services are located. The
static DNS configuration on the switch overrides the DNS configuration from the DHCP server.
1
Configure a VLAN:
2361# set vlan 1 port 7
success: change accepted.
2
Enable the DHCP client on VLAN 1:
2361# set interface 1 ip dhcp-client enable
success: change accepted.
3
Configure the default DNS domain name:
2361# set ip dns domain examplecorp.com
Domain name changed
4
Configure DNS server information:
2361# set ip dns server 192.168.11.2
5
Enable the WSS Software DNS client:
2361# set ip dns server enable
success: change accepted.
6
Enable the auto-config option:
2361# set auto-config enable
success: change accepted.
7
Create a self-signed administrative certificate, to enable the WSS to communicate with WLAN
Management Software :
2360# crypto generate key admin 1024
key pair generated
2360# crypto generate self-signed admin
Country Name:
State Name:
Locality Name:
Organizational Name:
Organizational Unit:
Common Name: remoteswitch1@example.com
320656-A