Adjusting The Forward And Backward Stitch - Dürkopp Adler D867 e-con Service Instructions Manual

Adjusting the mechanical stitch adjustment
Fig. 30: Adjusting the mechanical stitch adjustment (2)
(5) - Plates
5. Manually position the plates (5) so that they are parallel.
6. Tighten the screw (1).
7. Check whether the plates (5) are still parallel; if not, repeat the setting.
8. Remove the locking peg (2).
9. Press the cables back into the cable ducts (4).

6.2 Adjusting the forward and backward stitch

The forward and backward stitch are controlled by a stepper motor and
adjusted via software.
The calibration is performed only in the software and does not require that
you mechanically set an eccentric ( p. 182).
Service Instructions D867 e-con - 00.0 - 08/2023
While doing so, make sure not to damage the cables.
⑤
43