Setting The Position Of The Integrated Adjusting Disk Relative To The Arm Shaft - Dürkopp Adler 806N-111-10 Service Instructions Manual

Machine head 121
5.1.3 Setting the position of the integrated adjusting disk relative to
Fig. 43: Setting the position of the integrated adjusting disk relative to the arm shaft (1)
(1) - Arm cover
(2) - Hole
Important
All settings made using the adjusting disk are only correct if they are set
as described in the rules. When adjusting the arm shaft, check and, if nec-
essary, correct all settings listed below.
Proper setting
The groove (4) and slot A of the adjusting disk integrated on the toothed
belt wheel must be aligned with line X - Y.
To set the position of the integrated adjusting disk relative to the arm shaft:
1. Lock the arm shaft in place through the hole (2) in the groove (4) using
 It must be possible to insert the locking peg into the integrated adjust-
2. Remove the arm cover (1).
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
the arm shaft
WARNING
Risk of injury from moving parts!
Crushing.
Do not correct the position of the arm shaft unless
the machine is switched off.
①
②
a locking peg or a Ø 5 mm pin.
ing disk through the hole (3) at position A.
③
(3) - Hole
(4) - Groove
④
69