Positioning The Arm Shaft Crank - Dürkopp Adler M-TYPE H867 Service Manual

Positioning the arm shaft crank

6 Positioning the arm shaft crank
Correct setting
The three setscrews (3) on the arm shaft crank (1) are seated completely
on the surface. The arm shaft crank (1) is flush with the machine
casting (2).
Cover
• Arm cover (
Figure 13: Setting the arm shaft crank
Setting steps
1. Loosen the three setscrews (3) on the arm shaft crank (1).
2. Turn the arm shaft crank (1) such that the setscrews (3) are seated com-
3. Push the arm shaft crank (1) to the right as far as it will go and against
4. Screw the setscrews (3) on the arm shaft crank (1) firmly in place.
Service manual H867 Version 00.0 - 08/2013
WARNING
Risk of crushing
Switch the sewing machine off before you check and set the
position of the arm shaft crank.

Section 4.4.2 Removing and fitting the arm cover,
page 11)
(1) - Arm shaft crank
(2) - Machine casting
pletely on the surface of the arm shaft.
the machine casting (2).
(3) - Setscrews
19