Positioning The Arm Shaft Crank On The Arm Shaft - Dürkopp Adler D869 e-con Service Instructions Manual

Positioning the arm shaft crank on the arm shaft

4
Fig. 26: Positioning the arm shaft crank on the arm shaft
(1) - Arm shaft crank
(2) - Threaded pins
Proper setting
The 2 threaded pins (2) on the arm shaft crank (1) are seated completely
on the flat.
The arm shaft crank (1) is flush with the machine casting (3).
To position the arm shaft crank on the arm shaft:
1. Switch off the machine.
2. Disassemble the front cover ( p. 20).
3. Disassemble the thread tension plate ( p. 25).
4. Loosen the threaded pins (2).
5. Turn the arm shaft crank (1) such that the threaded pins (2) are seated
6. Push the arm shaft with the arm shaft crank (1) to the right as far as it
7. Tighten the threaded pins (2).
Service Instructions D869 e-con - 00.0 - 09/2023
Positioning the arm shaft crank on the arm shaft
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before positioning the arm
shaft.
completely on the flat of the arm shaft.
will go and flush with the machine casting (3).
(3) - Machine casting
①
②
③
37