Removing And Inserting The Feed-Dog - Dürkopp Adler M-TYPE H867 Service Manual

Working basis

4.4.7 Removing and inserting the feed-dog

Figure 7: Removing and inserting the feed-dog
(1) - Feed-dog
(2) - Feed-dog carrier
Removing the feed-dog
1. Remove the throat plate.
2. Loosen the feed-dog screws (3).
3. Take the feed-dog (1) off the feed-dog carrier (2).
Inserting the feed-dog
1. Place the feed-dog (1) onto the feed-dog carrier (2).
2. Screw the feed-dog screws (3) firmly in place.
3. Insert the throat plate.
Service manual H867 Version 00.0 - 08/2013
WARNING
Risk of injury
Switch the sewing machine off before you remove or insert the
feed-dog.
(  Section 4.4.6 Removing and inserting the throat plate, page 14)
(  Section 4.4.6 Removing and inserting the throat plate, page 14)
Important: Check the feed-dog position in its movement by turning the
handwheel. The feed-dog must not hit against the throat
plate.
(3) - Feed-dog screws
15