Sony MVS-8000X User Manual page 482

3
4
Setting the operating mode for each switcher bank
To set a desired switcher bank to Multi Program 2 mode, use the following
procedure.
1
2
3
4
Assigning output signals for Multi Program 2 mode
To assign signals to outputs
Use the Engineering Setup >Switcher >Config >M/E Output Assign menu.
The difference from standard mode is that OUT1 is fixed, set to PGM1 (main
program), and OUT6 is fixed, set to PGM2 (sub program), and that for the
OUT2 to OUT5 signals you can assign any signal selected from the following.
Notes
Each of main and sub can use a maximum of four of the six outputs (OUT1 to
OUT6). The outputs can be used within the following limits.
• OUT1, OUT2: main only
• OUT3, OUT4: can be used for either main or sub
• OUT5, OUT6: sub only
For details, see "Making Settings Required to Use the Software" in Chapter
18 (Volume 3).
To set the background and key configuration
Use the Engineering Setup >Switcher >Config >PGM Config menu.
The following are the differences from standard mode.
Background configuration: Consists of the following combinations.
482
Multi Program 2
Shut down the menus. (see page 137.)
Power the switcher and SCU off and on again.
Display the Engineering Setup >Switcher >Config menu.
Select the switcher bank from M/E-1 to M/E-4, and P/P.
In the <M/E Config> group, select [Multi Program2].
Repeat steps 2 and 3 as required, to set the operating mode for all desired
switcher banks.
PGM1, PGM2, PGM3, PGM4, PVW1, PVW2, K-PVW1, K-PVW2,
CLEAN, SUB CLEAN
• For main: Clean, Bkgd A, Bkgd B
• For sub: Sub Clean, Utility 2, Utility 3