3
Setting the transition rate in the numeric keypad control block
1
2
3
4
178
Executing a Transition
Press the [ENTR] button.
This confirms the entry, and the new setting appears in the transition
control block display.
TRANS RATE button
Region selection buttons
Numeric keypad control block
In the numeric keypad control block, press the [TRANS RATE] button.
Press the region selection button for the M/E or PGM/PST bank for which
you want to set the transition rate, turning it on.
The numeric keypad control block display now shows the selected region
name and the current transition rate setting for the region.
With the numeric keypad, enter the transition rate.
If required, press the [TC] button to toggle the input mode (frame input or
timecode input).
• Enter a value of up to three digits.
• To clear the entry, press the [CLR] button.
Press the [ENTER] button.
This confirms the entry, and the selected region name and the set transition
rate appear in the numeric keypad control block display.
Display
TC button
ENTER button
Numeric keypad