Downstream Key/Fade-To-Black Control Block - Sony MVS-8000X User Manual

Downstream Key/Fade-to-Black Control Block

1 Key delegation
buttons
a Key delegation buttons
Press DSK1 or DSK2, to select the keyer.
Each button can be assigned to any key in
setup (see "Overall Control Panel Settings
(Config Menu)" in Chapter 19 (Volume 3)).
While these buttons are held down, you can
select a key source with the cross-point
buttons on the key bus.
Pressing one of these buttons twice in rapid
succession changes its state so that you can
make cross-point selections on the
corresponding key bus in the PGM/PST
bank.
b Independent key transition
execution section
DSK1 ON, DSK2 ON buttons: Press these
to cut in the corresponding downstream
key 1 or 2. When the key is already
102
Names and Functions of Parts of the Control Panel
4 Key source name display/key snapshot buttons
3 K-SS button
2 Independent key
transition
6 AUTO button
execution section
AUTO TRANS buttons: The left button
c K-SS (key snapshot) button
Pressing this button, turning it on, enables
the key snapshot mode. In this mode, you
can save and recall key snapshots.
5 FTB button
7 Preview selection buttons
inserted, pressing the button cuts it out.
Each button lights red when the
corresponding key is inserted in the
program output (final output from the
switcher), and lights amber at other
times.
applies to DSK1 and the right button to
DSK2; press these buttons to carry out
an auto transition. The transition
immediately starts, and the button
lights amber. When the transition
completes, the button goes off.