Sony MVS-8000X User Manual page 234

4
5
234
Key Setting Operations Using Menus
• "Key drop OFF" mode
Knob Parameter Adjustment
1 Width Width
2 Position Position
3 Density Density
• "Key drop ON" mode
Knob Parameter Adjustment
1 Width Width
2 Position Position
3 Density Density
a) In the "4H mode" and when [Fine Key] (page 235) is on, the setting value range is 0.00
to 4.00.
When emboss is selected:
Knob Parameter Adjustment
1 Width Width
2 Position Position
3 a) Density
Density
a) The Density adjustment only affects the key edge. This can be adjusted separately from
Key Density, and if Key Density is set to 0.00, the embossed edge effect only can be
applied.
To make edge fill adjustments, carry out the settings in step 6.
Select the edge fill signal in the <Edge Fill> group.
Utility 1 Bus: signal selected on the utility 1 bus
Matte: signal from dedicated color matte generator.
It becomes possible to adjust color 1.
Knob Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
When the edge type is outline, in place of the edge fill signal, the selected
key fill signal fills the outline, and elsewhere remains as the background.
Carry out the following operation, depending on the selection in step 4.
Setting values
a)
0.00 to 8.00
359.99 to 180.00
0.00 to 100.00
Setting values
a)
0.00 to 8.00
359.99 to 0.00
0.00 to 100.00
Setting values
0.00 to 4.00
359.99 to 0.00
0.00 to 100.00
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00