Key Snapshot Operations Using A Simple Transition Module - Sony MVS-8000X User Manual

To recall a key snapshot
For example, to recall a key snapshot for M/E1 key 1 saved in register 1, with
the M/E1 region and key 1 selected, proceed as follows.
1
Press the [KEY SS] button.
2
According to the information you want to recall, set the following buttons
On/Off.
[MOD ENBL] button: Recall the key adjustment values and key modifier
settings.
[TRNS ENBL] button: Recall independent key transition settings.
If both are Off, then key memory is enabled, and just the saved key fill
and key source signal selections are recalled.
3
Press button [1] for the register you want to recall.
The [1] button lights yellow, and the key snapshot is recalled.
To cancel the recall operation, press the [UNDO] button.
To delete a key snapshot
For example, to delete a key snapshot for M/E1 key 1 saved in register 1, with
the M/E1 and key 1 region selected, proceed as follows.
1
Press the [KEY SS] button.
2
Holding down the [DEL] button, press the button [1] for the register in
which is saved the key snapshot you want to delete.
To carry out an auto transition execution during key snapshot
operation
Press the [AUTO TRNS] button.
Instant key insertion/removal
Press the [KEY ON] button.
To remove the key, while the key is inserted press the [KEY ON] button.
Key Snapshot Operations Using a Simple Transition
Module
When using a simple transition module, the key snapshots hold the settings for
key 3 and key 4. However, each key control block can be assigned to any key
in setup (see "Overall Control Panel Settings (Config Menu)" in Chapter 19
(Volume 3)).
287
Key Snapshots