To execute a transition on the M/E or PGM/PST bank by a button operation,
use the following procedure in the transition control block.
To carry out an instantaneous cut transition: Press the [CUT] button.
To carry out a gradual transition: Press the [AUTO TRANS] button.
This executes the transition at the preset transition rate (see page 176).
While the transition is executing, the [AUTO TRANS] button lights
amber. When it completes the button goes off.
To complete a partially executed transition instantaneously: Press the
[CUT] button.
The [AUTO TRANS] button goes off.
Executing a Transition With the Fader Lever (Manual
Transition)
Using the fader lever, you can manually control the progress of the transition.
Moving the fader lever from one end of its travel to the other completes the
transition.
To execute a manual transition with the transition control block fader lever, use
the following procedure.
To carry out the transition completely: Move the lever over the full range of
its travel.
Fader lever
AUTO TRANS button
CUT button
Transition control block (standard type)
185
Executing a Transition