Sony MVS-8000X User Manual page 154

When the [2ND] button is unlit
The cross-point buttons and reentry buttons in the auxiliary bus control block
have separate upper (1st row) and lower (2nd row) numbers.
In the case of a 32-button layout, the button numbers are as follows.
Button
1st row
2nd row
When the [2ND] button is lit
Different buses can be assigned to the 1st-row buttons and 2nd-row buttons.
When the 32nd button is set as a shift button, the 1st-row buttons and 2nd-row
buttons both have the following button numbers.
Button
From the left end to the
31st button
Reentry buttons
Inhibiting cross-point button operations
For each cross-point button, you can temporarily inhibit operations.
Notes
This setting is cleared when you reset the control panel.
Assigning a button to the function of disabling cross-point button
operation
You can assign the button to be used for the operation to the [PRE MCRO]
button, in setup. (See "Overall Control Panel Settings (Config Menu)" in
Chapter 19 (Volume 3).)
You can also use the [Inhibit Set] and [Inhibit All Clear] functions, assigned to
user preference buttons. (See "Setting Button Assignments (Prefs/Utility
Menu)" in Chapter 19 (Volume 3).)
Buses for which operations can be inhibited
This setting applies to the auxiliary bus control block (when using the CCP-
8000) and the cross-point buttons in each switcher bank. However, when using
154
Signal Selection
Auxiliary bus control block button numbers ([2ND] button unlit)
Button
From the left end to the 31st button
Reentry buttons
From the left end to the 31st button
Reentry buttons
Auxiliary bus control block button numbers ([2ND] button lit)
Number when the shift
button is not pressed
1 to 31
121 to 124
Button numbers
1 to 31
121 to 124
32 to 62
125 to 128
Number when the shift
button is pressed
32 to 62
125 to 128