Signal Name Display - Sony MVS-8000X User Manual

Notes
• For details of audio mixers that can be connected, contact your Sony service
or sales representative.
• When the signal is switched with a snapshot, keyframe, and so on, the audio
mixer is not linked.
• When bus fixed mode is selected in setup (see page 187), the audio mixer
program output is linked to the bus output as the background.

Signal Name Display

You can attach a name (source name) to each signal assigned to a cross-point
button, with a maximum of 16 characters.
• The source name displays in the cross-point control block and auxiliary bus
control block show the source names of the video signals assigned to
numbers 1 to 31.
• To display the source names for numbers 32 to 62, press the [SHIFT] button
to the right of the source name displays.
• To display the source names of the key signals assigned to buttons, hold
down the [SPLIT] button in the key control block or the [KEY] button in the
auxiliary bus control block.
When using the AUX panel-less function (see page 151) with the CCP-6224/
6324 Control Panel, you can use the cross-point control block as an AUX bus
control block with the [AUX CTRL] button.
In this case, use the key 1 row as AUX delegation buttons, and the key 2 row
as AUX bus cross-point selection buttons; the source name displays show the
bus names and source names.
Colors of lit cross-point buttons
In a particular row of cross-point buttons, only the last pressed button is
effective, and lights amber or red. The amber indicates the "low tally" state,
and the red indicates the "high tally" state, to indicate whether or not the
selected signal appears in the final output video.
Color
Amber
Red
156
Signal Selection
Significance of colors of lit cross-point buttons
State
Low tally
High tally
Significance
Does not appear in final output video
Appears in final output video