Sony MVS-8000X User Manual page 219

For an overview of the key types, see "Key Types" (page 210).
3
Carry out the following settings as required, depending on the key type
selected in step 2.
To enable clean mode (see page 211) for a luminance key, linear key or
color vector key: Select [Clean Mode] so that it is set on.
When clean mode is enabled, key fill is added to the background
without cutting out with key source.
When chroma key is selected: Select [Chroma Adjust] to access the
Chroma Adjust menu (see page 224), and make the required settings.
When a wipe pattern key is selected: In the M/E-1 >Wipe menu (see
page 293), select the pattern and set any modifiers, then return to the
M/E-1 >Key1 menu.
When a key wipe pattern key is selected: In the M/E-1 >Key1 >
Transition >Wipe Adjust menu (see page 319), carry out pattern
selection and modifier setting, then return to the M/E-1 >Key1 >Type
menu.
Notes
For a wipe pattern selected for a wipe pattern key or key wipe pattern key,
the [Edge] and [Direction] modifier settings are not available.
4
Set the parameters.
• When a luminance key or linear key is selected
Knob Parameter
1 Clip
2 Gain
3 Density
4 Filter
a) Setting this value to 1, produces the "through" state in which no filter is applied. The larger
the value, the more strongly the filter applies.
• When a chroma key is selected
Knob Parameter
3 Density
Adjustment
Reference level for generating the
key signal
Key sensitivity
Key density
Filter coefficient
Adjustment
Key density
Key Setting Operations Using Menus
Setting values
+109.59 to –7.31
–100.00 to +100.00
0.00 to 100.00
a)
1 to 9
Setting values
0.00 to 100.00
219