Port And Interface Numbering On Mx80-48T Routers; Figure 19: Mx80-48T Interface Port Mapping; Table 15: Mx80-48T Components And Interface Names - Juniper MX10 Hardware Manual

MX5, MX10, MX40, and MX80 3D Universal Edge Router Hardware Guide
Table 14: MX5, MX10, MX40, and MX80 Components and Their Interface Names (continued)
Component
Multiservices MIC installed in the rear of the
chassis (no external ports)

Port and Interface Numbering on MX80-48T Routers

Table 15: MX80-48T Components and Interface Names

Component
Built-in 4-port 10-Gigabit Ethernet MIC
32
Name in the CLI
MS-MIC-16G
Each MX80-48T router contains two built-in MPCs, which are represented in the CLI as
and (see Figure 19 on page
FPC 0 FPC 1

Figure 19: MX80-48T Interface Port Mapping

FPC 1, PIC 0 FPC 1, PIC 1
1 3 5 7 9 11
0 2 4 6 8 10
Port numbers
MPC 0 ( ) contains a 4-port 10-Gigabit Ethernet MIC and is built into the front of
FPC 0
the chassis. The MIC is represented as
PIC, which is represented as
MPC 1 ( ) contains a 48-port Tri-Rate MIC and is built into the front of the chassis.
FPC 1
The MIC is represented as
are numbered 0 through 3. Each logical PIC on the built-in Tri-Rate MIC contains twelve
ports, which are numbered 0 through 11 (see
Table 15 on page 32 summarizes the relationship between the components and the
interface names.
Name in the CLI
4x 10GE XFP
32).
FPC 1, PIC 2
in the CLI and is logically divided into a single
MIC 0
PIC 0 .
in the CLI and is logically divided into four PICs, which
MIC 0
Figure 19 on page
Interface Names
xe-0/0/0
Interface Names
ge/0/2/0
Type = ms
fpc = 0
pic = 2
port = 0
FPC 1, PIC 3
MX80-48T
FPC 0, PIC 0
32).
through xe-0/0/3
Copyright © 2017, Juniper Networks, Inc.