Replacing Cooling System Component; Installing An Mx5, Mx10, Mx40, And Mx80 Air Filter - Juniper MX10 Hardware Manual

CHAPTER 18

Replacing Cooling System Component

Installing an MX5, MX10, MX40, and MX80 Air Filter

Copyright © 2017, Juniper Networks, Inc.
Installing an MX5, MX10, MX40, and MX80 Air Filter on page 107
Replacing an MX5, MX10, MX40, and MX80 Air Filter on page 108
Installing an MX5, MX10, MX40, and MX80 Fan Tray on page 110
Replacing an MX5, MX10, MX40, and MX80 Fan Tray on page 111
The air filter installs on the right side of the fan tray. To install the air filter (see
Figure 42 on page 108):
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Locate the
2. THIS SIDE MUST FACE OUT
up.
Insert the air filter into the groove located toward the front of the fan tray.
3.
Press the tab on the rear of the fan tray to allow the air filter to slide into place.
4.
Release the tab to secure the air filter.
5.
label, and ensure that the air filter is right side
107