Mx5, Mx10, Mx40 And Mx80 Chassis Lifting Guidelines; Ramp Warning - Juniper MX10 Hardware Manual

MX5, MX10, MX40, and MX80 3D Universal Edge Router Hardware Guide
Related
Documentation

MX5, MX10, MX40 and MX80 Chassis Lifting Guidelines

Ramp Warning

198
Varning! Läs installationsanvisningarna innan du kopplar systemet till dess
strömförsörjningsenhet.
General Safety Guidelines and Warnings on page 189
Laser and LED Safety Guidelines and Warnings on page 205
Grounded Equipment Warning on page 203
The weight of a fully configured chassis is about 30 lb (13.6 kg). Observe the following
guidelines for lifting and moving the router:
Before moving the router, read the guidelines in
Preparation Checklist" on page 44
power, environmental, and clearance requirements.
Before lifting or moving the router, disconnect all external cables.
To lift routing devices and components, use the following lifting guidelines:
Up to 39.7 lb (18 kg): One person.
39.7 lb (18 kg) to 70.5 lb (32 kg): Two or more people.
70.5 lb (32 kg) to 121.2 lb (55 kg): Three or more people.
Above 121.2 lbs (55 kg): Material handling systems (such as levers, slings, lifts and
so on) must be used. When this is not practical, specially trained persons or systems
must be used (riggers or movers).
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
WARNING: When installing the device, do not use a ramp inclined at more
than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
"MX5, MX10, MX40, and MX80 Site
to verify that the intended site meets the specified
Copyright © 2017, Juniper Networks, Inc.