Installing an MX10, MX40, MX80, and MX104 Dual-Wide MIC
Copyright © 2017, Juniper Networks, Inc.
Figure 55: Installing a MIC
To install a dual-wide MIC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
If the MIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver
2.
on the faceplate. Install a cap if necessary.
Remove the septum, if necessary (see
3.
Lift the latch in the center of the two MIC slots to disengage the septum from the
a.
chassis.
Slide the septum toward you, and then lift the septum out of the slot.
b.
Store the septum for later use.
c.
Chapter 19: Replacing Line Card Components
Figure 51 on page
118):
Figure 50 on page
116):
123