Figure 52: Removing A Mic; Figure 53: Removing A Dual-Wide Mic - Juniper MX10 Hardware Manual

MX5, MX10, MX40, and MX80 3D Universal Edge Router Hardware Guide
120
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Pull the ejector lever above the MIC you are removing away from the router. Pulling
7.
the ejector lever disconnects the MIC from the chassis.
NOTE: To remove a dual-wide MIC that takes up both MIC slots, you must
pull both ejector levers.
Grasp the handles on the MIC faceplate, and slide the MIC out of the chassis. Place
8.
it in the electrostatic bag or on the antistatic mat.
If you are not reinstalling a MIC into the emptied MIC slot within a short time, install
9.
a blank MIC panel over the slot to maintain proper airflow in the chassis card cage.

Figure 52: Removing a MIC

Figure 53: Removing a Dual-Wide MIC

Ejector levers
Copyright © 2017, Juniper Networks, Inc.