Installing An Mx5, Mx10, Mx40, And Mx80 Ac Power Supply; Figure 61: Installing An Ac Power Supply - Juniper MX10 Hardware Manual

MX5, MX10, MX40, and MX80 3D Universal Edge Router Hardware Guide

Installing an MX5, MX10, MX40, and MX80 AC Power Supply

Related
Documentation
138
To install an AC power supply (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Move the AC input switch next to the appliance inlet on the power supply to the off (
2.
position.
Using both hands, slide the power supply straight into the chassis until the power
3.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate or blank installed in the power supply slot.
Attach the power cord to the power supply.
4.
Attach the power cord to the AC power source, and switch on the dedicated customer
5.
site circuit breaker. Follow the instructions for your site.
Move the AC input switch next to the appliance inlet on the power supply to the on (
6.
| ) position and observe the status LED on the power supply faceplate. If the power
supply is correctly installed and functioning normally, the status LED lights green
steadily.

Figure 61: Installing an AC Power Supply

MX5, MX10, MX40, and MX80 Power System Description on page 35
MX5, MX10, MX40, and MX80 Routers AC Power Specifications on page 53
AC Power Circuit Breaker Requirements for the MX5, MX10, MX40, and MX80 Router
on page 56
AC Power Cord Specifications for MX5, MX10, MX40, and MX80 Routers on page 56
Figure 59 on page 136):
Copyright © 2017, Juniper Networks, Inc.
O )