Powering Off Mx5, Mx10, Mx40, And Mx80 Routers - Juniper MX10 Hardware Manual

Related
Documentation

Powering Off MX5, MX10, MX40, and MX80 Routers

Copyright © 2017, Juniper Networks, Inc.
Chapter 15: Connecting the MX5, MX10, MX40, and MX80 Routers to Power
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on. After powering on a power supply, wait at least 60
seconds before turning it off.
If the system is completely powered off when you power on the power
supply, the Routing Engine boots as the power supply completes its startup
sequence. If the Routing Engine finishes booting and you need to power
off the system again, first issue the CLI
After a power supply is powered on, it can take up to 60 seconds for status
indicators—such as the status LEDs on the power supply and the
show chassis
functioning normally. Ignore error indicators that appear during the first
60 seconds.
On the external management device connected to the Routing Engine, monitor the
10.
startup process to verify that the system has booted properly.
Tools and Parts Required for MX5, MX10, MX40, and MX80 Router Grounding and
Power Connections on page 87
Connecting Power to an AC-Powered MX5, MX10, MX40, and MX80 Router on page 89
MX5, MX10, MX40, and MX80 Router Grounding Specifications on page 43
request system halt
show chassis power
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on.
To power off the router:
On the external management device connected to the Routing Engine, issue the
1.
command.
request system halt
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
2.
has halted. For more information about the command, see the
command display—to indicate that the power supply is
command.
request system halt
.
CLI Explorer
95