Installing An Mx5, Mx10, Mx40, And Mx80 Transceiver - Juniper MX10 Hardware Manual

Related
Documentation

Installing an MX5, MX10, MX40, and MX80 Transceiver

Copyright © 2017, Juniper Networks, Inc.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
Insert the other end of the cable into the destination port.
5.
Repeat the previous steps for any additional cables.
6.
If the MIC is offline (its failure indicator LED is lit), use one of the following methods
7.
to bring it online:
Press the MIC offline/online button until the MIC LED lights green.
Issue the following CLI command:
user@host>request chassis mic fpc-slot slot-number mic-slot slot-number online
The normal functioning indicator LED confirms that the component is online. You can
also verify correct MIC functioning by issuing the
MX5, MX10, MX40, and MX80 Modular Interface Card Description on page 23
Removing a Cable on an MX5, MX10, MX40, and MX80 MIC on page 126
Replacing an MX5, MX10, MX40, and MX80 SFP or XFP Transceiver on page 130
Preventing Electrostatic Discharge Damage to an MX5, MX10, MX40, and MX80 Router
on page 194
request chassis mic
show chassis fpc
To install an SFP or XFP:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
2.
on the component where it will be installed.
Chapter 19: Replacing Line Card Components
show chassis fpc pic-status command.
129