Juniper MX10 Hardware Manual page 79

Table 28: AC Power Cord Specifications (continued)
Country
Europe (except Italy and
United Kingdom)
Italy
Japan
North America
United Kingdom
Copyright © 2017, Juniper Networks, Inc.
Model Number
CBL-JX-PWR-EU
CBL-JX-PWR-IT
CBL-JX-PWR-JP
CBL-JX-PWR-US
CBL-JX-PWR-UK
WARNING: The AC power cord for the router is intended for use with the
router only and not for any other use.
WARNING: The attached power cable is only for this product. Do not use the
cable for another product. Translation in Japanese follows:
NOTE: In North America, AC power cords must not exceed approximately
14.75 ft (4.5 m) in length, to comply with National Electrical Code (NEC)
Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code
(CEC) Section 4-010(3). You can order AC power cords that are in compliance.
WARNING: The router is pluggable type A equipment installed in a
restricted-access location. It has a separate protective earthing terminal
(sized for SAE 10-32 ground screws) provided on the chassis in addition to
the grounding pin of the power supply cord. This separate protective earthing
terminal must be permanently connected to earth.
CAUTION: Power cords and cables must not block access to device
components or drape where people could trip on them.
Chapter 8: AC Power Specifications and Requirements
Electrical Specification
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
125 VAC, 12 A, 50 Hz or 60 Hz
125 VAC, 10 A, 60 Hz
250 VAC, 10 A, 50 Hz
Plug Type
CEE (7) VII
CEI 23–16/VII
JIS 8303
NEMA 5-15
BS 1363A
57