Connecting The Mx5, Mx10, Mx40, And Mx80 Routers To The Network; Connections; Connecting Mx5, Mx10, Mx40, And Mx80 Routers To Management Devices; Connecting The Router To A Network For Out-Of-Band Management - Juniper MX10 Hardware Manual

CHAPTER 16
Connecting the MX5, MX10, MX40, and
MX80 Routers to the Network
Tools and Parts Required for MX5, MX10, MX40, and MX80 Router Connections
Related
Documentation

Connecting MX5, MX10, MX40, and MX80 Routers to Management Devices

Connecting the Router to a Network for Out-of-Band Management

Copyright © 2017, Juniper Networks, Inc.
Tools and Parts Required for MX5, MX10, MX40, and MX80 Router
Connections on page 97
Connecting MX5, MX10, MX40, and MX80 Routers to Management Devices on page 97
Connecting Interface Cables to MX5, MX10, MX40, and MX80 Routers on page 99
To connect the router to management devices and line cards, no tools or parts are
required.
Installing the MX5, MX10, MX40, and MX80 Cable Management Bracket on page 79
Connecting MX5, MX10, MX40, and MX80 Routers to Management Devices on page 97
Connecting Interface Cables to MX5, MX10, MX40, and MX80 Routers on page 99
Connecting the Router to a Network for Out-of-Band Management on page 97
Connecting the Router to a Management Console or Auxiliary Device on page 98
To connect to the
ETHERNET
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable
2.
the port on the Routing Engine.
ETHERNET
Plug the other end of the cable into the network device.
3.
port on the Routing Engine:
(Figure 37 on page 98
Figure 38 on page 98
shows the connector) into
shows the port.
97