Connecting An Mx5, Mx10, Mx40, And Mx80 Dc Power Supply Cable - Juniper MX10 Hardware Manual

Connecting an MX5, MX10, MX40, and MX80 DC Power Supply Cable

Copyright © 2017, Juniper Networks, Inc.
WARNING: Before performing DC power procedures, ensure that power is
removed from the DC circuit. To ensure that all power is off, locate the circuit
breaker on the panel board that services the DC circuit, switch the circuit
breaker to the off position, and tape the switch handle of the circuit breaker
in the off position.
To connect a power cable for a DC power supply:
Locate a replacement power cable that meets the specifications.
1.
Verify that a licensed electrician has attached a cable lug to the replacement power
2.
cable.
Verify that the status LED is off.
3.
Secure each power cable lug to the terminal with the screw (see
4.
Apply between 5 lb-in. (0.6 Nm) and 6 lb-in. (0.7 Nm) of torque to screw. Do not
overtighten the nut. (Use a number 2 Phillips screwdriver.)
CAUTION: Ensure that each power cable lug seats flush against the surface
of the terminal block as you are tightening the screws. Ensure that each
screw is properly threaded into the terminal. Applying installation torque
to the screw when improperly threaded may result in damage to the
terminal.
CAUTION: The maximum torque rating of the terminal screws on the DC
power supply is 6 lb-in. (0.7 Nm). The terminal screws may be damaged
if excessive torque is applied. Use only a torque-controlled driver to tighten
screws on the DC power supply terminals. Use an appropriately-sized
driver, with a maximum torque capacity of 6 lb-in. or less. Ensure that the
driver is undamaged and properly calibrated and that you have been
trained in its use. You may wish to use a driver that is designed to prevent
overtorque when the preset torque level is achieved.
Chapter 20: Replacing Power System Components
Figure 68 on page 150).
149