Warning Statement For Norway And Sweden; Router - Juniper MX10 Hardware Manual

MX5, MX10, MX40, and MX80 3D Universal Edge Router Hardware Guide
Related
Documentation

Warning Statement for Norway and Sweden

Related
Documentation
Preventing Electrostatic Discharge Damage to an MX5, MX10, MX40, and MX80 Router
194
We recommend that you dispose of any irreparably damaged equipment in an
environmentally responsible manner.
General Safety Guidelines and Warnings on page 189
General Electrical Safety Guidelines and Warnings on page 215
Action to Take After an Electrical Accident on page 226
WARNING: The equipment must be connected to an earthed mains
socket-outlet.
Advarsel Apparatet skal kobles til en jordet stikkontakt.
Varning! Apparaten skall anslutas till jordat nätuttag.
General Safety Guidelines and Warnings on page 189
Many router hardware components are sensitive to damage from static electricity. Some
components can be impaired by voltages as low as 30 V. You can easily generate
potentially damaging static voltages whenever you handle plastic or foam packing
material or if you move components across plastic or carpets. Observe the following
guidelines to minimize the potential for electrostatic discharge (ESD) damage, which
can cause intermittent or complete component failures:
Always use an ESD wrist strap or ankle strap, and make sure that it is in direct contact
with your skin.
CAUTION: For safety, periodically check the resistance value of the ESD
strap. The measurement should be in the range of from 1 to 10 Mohms.
When handling any component that is removed from the chassis, make sure the
equipment end of your ESD strap is attached to one of the electrostatic discharge
points on the chassis (see
Avoid contact between the component and your clothing. ESD voltages emitted from
clothing can still damage components.
When removing or installing a component, always place it component-side up on an
antistatic surface, in an antistatic card rack, or in an electrostatic bag (see
Figure 78 on page 195). If you are returning a component, place it in an electrostatic bag
before packing it.
Figure 77 on page 195).
Copyright © 2017, Juniper Networks, Inc.