Service Functions; Accessing The Service Functions - Nellcor OXIMAX N-595 Service Manual

Service
Functions
Accessing the

Service Functions

N-595
Table 3: Adult Alarm Factory Defaults
Monitoring Mode
Note: Bold entries are different than neonate default settings.
Data Port Protocol
Display Contrast
Display Format
In-Sensor Trend
Language
Nurse Call Polarity
Pulse Beep Volume
Pulse Rate Lower Alarm Limit
Pulse Rate Upper Alarm Limit
SatSeconds
Sensor Adjust Enabled
Trend Display
Service functions can be used to select institutional defaults and to access
information about the patient or instrument. Only a Nellcor Customer Service
Engineer should access some of the items available through the service
functions. These items will be noted in the text that follows.
All service functions are accessible only if the DOC-10 pulse oximetry cables
are disconnected from the monitor.
1. Turn on the N-595 by pressing the POWER ON/OFF button.
2. Wait for monitor power-on self-test to complete.
3. Simultaneously press and hold the LIGHT softkey and the CONTRAST
button until the service softkeys are displayed.
Power-On Settings and Service Functions
Setting
ASCII
Midrange
Pleth
SpO
2
English
Normally Low
4 of 10
40 beats per minute
170 beats per minute
Off
Yes
%SpO
2
31