Pulse Oximetry Functional Tests - Nellcor OXIMAX N-595 Service Manual

Pulse Oximetry
Functional Tests
N-595
6. The monitor should stabilize on the subject's physiological signal in about
15 to 30 seconds. Verify that the oxygen saturation and pulse rate values
are reasonable for the subject.
These tests utilizes the pulse oximetry functional tester (SRC-MAX) to verify
the performance of the N-595 monitor.
All of these tests should be done in sequence.
1 DOC-10 Cable Connector
2 RED LED Drive Indicator
3 Not Used For N-595
4 Not Used For N-595
5 Battery Low Indicator
Performance Verification
6 % Modulation Select Button
7 % SpO Select Button
2
8 Light Level Selection Button
9 Pulse Rate Selection Button
10 INFRARED LED Drive
Indicator
23