Carburetor Separation - Honda C8R600F4 Service Manual

CARBURETOR SEPARATION
NOTE:
The vacuum chamber and tloat chamber can be
serviced without separating the carburetors.
Remove the following:
-throttle stop screw with spring and washer
-carburetor insulators by loosing band screws
-two screws and washers
-SE valve arm and return spring
-two collars
-front connecting nut, screw and throttle sensor.
CAUTION:
Do not remove the throttle sensor from the brack-
et unless it requires replacement. It may cause the
sensor to move out of position resulting in improp-
er ignition timing.
-connecting nut, bolt and joint retainer
-air vent hose joint with 0-ring
-screw and throttle cable holder (joint retainer)
-dowel pin
-air vent hose joint with 0-ring.
Loosen the synchronization adjusting screws to
reduce the spring tension and remove the synchro-
nization springs.
FUEL SYSTEM
5-17