Honda C8R600F4 Service Manual page 144

ENGINE REMOVAL/INSTALLATION
Hold the center hanger bolt (right side) and loosen
the lock nut using the special tool.
TOOL:
Lock nut wrench
07VMA-M
B BO
100
Hold the rear hanger nut and loosen the lock nut
using the same tool.
Remove the following:
-center hanger bolt (right side)
- rear hanger nut bolt and spacers
-lock nuts and adjusting bolts
-engine from the frame.
ENGINE INSTALLATION
7-6
NOTE:
•When tightening the lock nut with the lock nut
wrench, refer to torque wrench reading informa-
tion on page 7-2 "SERVICE INFORMATION".
•The jack height must be continually adjusted to
relieve stress from the mounting fasteners.
•Route the wires and cables properly (page 1-18).
CAUTION:
Be sure to tighten all engine mounting fasteners to
the specified torque in the specified sequence
described following page. If you mistake the
tightening torque or sequence, loosen all
mounting fasteners, then tighten them again to
the specified torque in the specified sequence.