Honda C8R600F4 Service Manual page 236

FRONT WHEEL/SUSPENSION/STEERING
WHEEL RIM
Check the rim runout by placing the wheel in a
truing st;:;ind
Spin the wheel slowly and read the runout using a
dial indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMITS: Radial: 2.0 mm (0.08 in)
Axial:
2.0 mm (0.08 in)
WHEEL BEARING
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tightly in
the hub.
Replace the wheel
Remove and discard the bearings if the races do
bearings in pairs.
not turn smoothly and quietly, if they fit loosely in
the hub.
DISASSEMBLY
Remove the dust seals from the wheel hub.
Remove the disc bolts and brake discs from the
wheel hub.
Replace the wheel
Install the bearing remover head into the bearing.
bearings in pairs.
From opposite side, install the bearing remover
Do not reuse old
shaft and drive the bearing out of the wheel hub.
bearings.
13-8
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover shaft
Bearing remover head,
20mm
07746-0050100 or
equivalent commercially
available in U.S.A.
077 46-0050600 or
equivalent commercially
available in U.S.A.
WHEEL
BEARING