Honda C8R600F4 Service Manual page 183

Using the special tools, press the needle bearing in
the clutch outer until the depth below the raised
portion of the clutch outer surface (oil pump drive
sprocket side) is 0.4-0.6 mm.
TOOLS:
Driver 07749-0010000
Attachment, 42
x
47 mm 07746-0010300
Pilot,
35 mm
077 46-0040800
ASSEMBLY
If removed, install
Coat the clutch outer guide with molybdenum oil
the gearshift
solution and install it onto the mainshaft with the
linkage
flange side facing the crankcase.
(page 9- 13).
Install the oil pump drive sprocket (with the pins
facing out), drive chain and driven sprocket as a set
with the "OUT" mark on the driven sprocket facing
out.
Apply locking agent to the oil pump driven sprocket
bolt threads.
Install the bolt with lht:i washt:ir am.I Lil:Jhlt:in it..
TORQUE : 15 N·m ( 1.5 kgf·m, 11 I bf.ft)
Be careful not to
Align the gear teeth of the scissors gears (primary
bend the ignition
drive gear and sub-gear) by prying the gears with a
pulse generator
screwdriver, then install the clutch outer.
rotor tangs.
Align the holes in the clutch outer with the pins on
the oil pump drive sprocket by turning the oil pump
driven sprocket while pushing in the clutch outer.
CLUTCH/GEARSHIFT LINKAGE
9-9