Honda C8R600F4 Service Manual page 210

CRANKCASE/TRANSMISSION
11-12
Apply locking agent to the set plate bolt threads.
Install the bearing set plate with "OUT SIDE" mark
facing out and tighten the three bolts.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf.ft)
Install the timing sprocket and the ignition pulse
generator rotor, aligning the wide groove with the
wide tooth.
Install the bolt with the washer and tighten it.
TORQUE : 59 N·rn (6.0 kgf·m, 43 lbf·ft)
Install the cam chain.
Apply locking agent to the pivot bolt threads.
Install the cam chain tensioner, washer (between
the tensioner and crankcase) and pivot bolt.
Tighten tho bolt.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf.ft)
Install the cam chain guide and washer bolt.
Tighten the bolt.
TORQUE: 12 N·rn (1.2 kgf·rn, 9 lbf-ft)
Install a new 0-ring into the groove in the water
hose joint.
Install the hose joint with the spout facing down
and tighten the bolts.
SET PLATE BOLTS