Honda C8R600F4 Service Manual page 80

LUBRICATION SYSTEM
Install the drive pin into the pump shaft.
Install the pump shaft by aligning the pin with the
grooves in the inner rotor.
Install the thrust washer onto the inner rotor.
Install the pump cover and dowel pins, and tighten
the bolt.
TORQUE : 8 N-m (0.8 kgf.m , 5.8 I bf.ft)
INSTALLATION
Install the oil pump onto the crankcase while align-
ing the pump shaft lug with the water pump shaft
groove by turning the pump shaft.
Install the pump mounting bolts and tighten them.
Install the clutch assembly (page 9-9).
OIL COOLER
REMOVAL
Remove the oil filter (page 3-12).
Drain the coolant from the system (page 6-5).
Disconnect the water hoses from the oil cooler.