Honda C8R600F4 Service Manual page 137

INSTALLATION
Pour the molybdenum oil solution into the hole in
the water pump as shown.
Apply mulybuer1w11 uil solulio11 to the Liu usl
washer.
Apply engine oil to a new 0-ring and install it onto
the stepped portion of the water pump.
Install the water pump into the crankcase while
aligning the water pump shaft groove with the oil
pump shaft end by turning the pump shaft.
Align the bolt holes in the water pump and
crankcase and make sure the water pump is secure-
ly
installed
Connect the water hoses to the pump body.
Install a new 0-ring into the groove in the water
pump body.
Install the water pump cover and tighten the bolts
with a new sealing washer.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf.ft)
Connect the water hoses and tube.
Fill and bleed the cooling system (page 6-4).
COOLING SYSTEM
~SEALING
WASHER
6-13