Engine Oil Filter - Honda C8R600F4 Service Manual

MAINTENANCE
ENGINE OIL FILTER
3-12
NOTE:
Change the oil with engine warm and the motorcy-
cle on its side stand to assure complete and rapid
draining.
Engine and exhaust system parts become very hot
and remain hot for some time after the engine is
run. Wear insulated gloves.
Warm up the engine.
Stop the engine and remove the side and inner fair-
ings (page 2-4).
Remove oil filler cap and drain bolt, and drain the
oil.
Remove the oil filter cartridge and let the remaining
oil drain out. Discard the filter cartridge.
TOOL:
Oil filter wrench 07HAA-PJ70100
CAUTION:
U:.ed engine oil may cause :skin cancer if re-
peatedly left in contact with the skin for prolonged
periods. Although this is unlikely unless you han·
die used oil on a daily basis, it is still advisable to
thoroughly wash your hands with soap and water
as soon as possible after handling used oil.
Apply oil to the 0-ring and threads of a new oil fil-
ter cartridge and install the filter cartridge.
TORQUE; 10 N·m (1.0 kgf·m, 7 lbf·ft)
After draining the oil completely check that the seal-
ing washer on the drain bolt is in good condition
and replace it if necessary.
Install and tighten the drain bolt.
TOROIJF :
?~
N.m (3.0 kgf.m, 22 !bf.ft)
Fill the crankcase with the recommended oil (page
3-10).
OIL CAPACITY: 3.3
Q
(3.5 US qt, 2.9 Imp qt)
after draining/filter change
3.7
Q
(3.9 US qt, 3.3 Imp qt)
at disassembly
Reinstall the oil filler cap.
Check the engine oil level (page 3-11 ).
Make sure there are no oil leaks.
Install the side and inner fairings (page 2-4).