Honda C8R600F4 Service Manual page 132

COOLING SYSTEM
Install the thermostat housing cover and tighten the
cover bolts.
TORQUE: 1? N.m (1.2 kgf.m, 9 lbf.ft)
Install the carburetor (page 5-30).
Fill and bleed the cooling system (page 6-4).
RADIATOR/COOLING FAN
6-8
CAUTION:
Be careful not to damage the radiator fins while
servicing the radiator.
RADIATOR REMOVAL/
INSTALLATION
Drain the coolant from the system by removing the
drain bolt on the water pump (page 6-5).
Disconnect the fan motor 2P (Black) connector.
Disconnect the horn connectors. Remove the horn
bolt and horn.
Disconnect the water hoses and tubes from the
ldUidlUI.
Remove the radiator mounting bolts, washers and
nut.
Remove the radiator from the mounting boss of the
frame.
Remove the air guide rubber from the engine.
Installation is in the reverse order of removal.
NOTE:
Set the air guide rubber properly, being careful not
to pinch it between the frame and radiator.
Fill and bleed the cooling system (page 6-4).