Dell SMA 200 Administration Manual page 414

7 Click Accept to save the configuration changes.
8 Navigate to the Nx Settings tab.
9 To set a client address range, enter a beginning address in the Client Address Range Begin field and an
ending address in the Client Address Range End field.
10 To set a client IPv6 address range, enter a beginning IPv6 address in the Client IPv6 Address Range
Begin field and an ending IPv6 address in the Client IPv6 Address Range End field.
11 In the Exit Client After Disconnect drop-down list, select Enabled or Disabled.
12 In the Uninstall Client After Exit drop-down list, select Enabled or Disabled.
13 In the Create Client Connection Profile drop-down list, select Enabled or Disabled.
14 In the User Name & Password Caching drop-down list, select one of the following:
• Allow saving of user name only - Allow caching of the user name on the client. Users only need
to enter their password when starting NetExtender.
• Allow saving of user name & password - Allow caching of the user name and password on the
client. Users are automatically logged in when starting NetExtender, after the first login.
• Prohibit saving of user name & password - Do not allow caching of the user name and
password on the client. Users are required to enter both user name and password when starting
NetExtender.
15 Navigate to the Nx Routes tab.
16 In the Tunnel All Mode drop-down list, select Enabled to force all traffic for the user, including traffic
destined to the remote user's local network, over the Secure Mobile Access NetExtender tunnel. Tunnel
All Mode is disabled by default.
17 To add a client route, click Add Client Route...
18 In the Add Client Route window, enter a destination network in the Destination Network field. For
example, enter the IPv4 network address 10.202.0.0. For IPv6, enter the IPv6 network address in the
form 2007::1:2:3:0.
19 For an IPv4 destination network, type the subnet mask in the Subnet Mask/Prefix field using decimal
format (255.0.0.0, 255.255.0.0, or 255.255.255.0). For an IPv6 destination network, type the prefix,
such as 112.
20 Click Add.
21 Click Accept to save the configuration changes.
22 Navigate to the Policies tab.
23 To add a policy, click Add Policy...
24 In the Apply Policy To drop-down list, select one of the following: IP Address, IP Address Range, All
Addresses, Network Object, Server Path, URL Object, All IPv6 Address, IPv6 Address, or IPv6
Address Range.
25 Enter a name for the policy in the Policy Name field.
26 In the fields that appear based on your Apply Policy To settings, fill in the appropriate information. For
example, if you select IP Address in the Apply Policy To drop-down list, you need to supply the IP
Address in the IP Address field and the service in the Service drop-down list. If you select IPv6 Address
Range, enter the beginning IPv6 address in the IPv6 Network Address field and the prefix that defines
the IPv6 address range in the IPv6 Prefix field. Optionally enter a port range (80-443) or a single port
number into the Port Range/Port Number field. This field is available when you select IP Address, IP
Address Range, IPv6 Address, or IPv6 Address Range in the Apply Policy To drop-down list.
27 Click Accept to save the configuration changes.
28 Click the Bookmarks tab.
29 To add a bookmark, click Add Bookmark...
30 Enter a bookmark name in the Bookmark Name field.
Dell SonicWALL Secure Mobile Access 8.5
Administration Guide
414