Configuring Web Application Firewall Settings - Dell SMA 200 Administration Manual

Configuring Web Application Firewall Settings

The Web Application Firewall > Settings page allows you to enable and disable Web Application Firewall on
your SMA/SRA appliance globally and by attack priority. You can individually specify detection or prevention for
three attack classes: high, medium, and low priority attacks.
This page also provides configuration options for other Web Application Firewall settings. The following sections
describe the procedures for enabling and configuring Web Application Firewall settings:
• Enabling Web Application Firewall and Configuring General Settings
• Configuring Global Exclusions
• Configuring Intrusion Prevention Error Page Settings
• Configuring Cross-Site Request Forgery Protection Settings
• Configuring Cookie Tampering Protection Settings
• Configuring Web Site Cloaking
• Configuring Information Disclosure Protection
• Configuring Session Management Settings
Enabling Web Application Firewall and Configuring General
Settings
To enable and activate Web Application Firewall, you must select the check box to globally enable it and select
at least one of the check boxes in the Signature Groups table. The settings in the General Settings section on
this page allow you to globally manage your network protection against attacks by selecting the level of
protection for high, medium, or low priority attacks. You can also clear Global Enable Web Application
on page 280
on page
on page
on page 284
on page
on page 286
on page 279
281
on page 282
283
285
Dell SonicWALL Secure Mobile Access 8.5
Administration Guide
279