Service and Repair Manual
Engines
Engin es
4-1 R PM Adj ustm ent - D eutz D 2011L03i M odels
4-1
RPM Adjustment
Deutz D2011L03i models:
Refer to Maintenance Procedure in the appropriate
Service or Maintenance Manual for your machine,
Check and Adjust the Engine RPM.
Ford MSG-425 and Deutz D 2.9 L4 Models:
Note: The engine rpm is controlled by the ECM and
can only be adjusted by reprogramming the ECM.
If rpm adjustment or service is required, please
contact Genie Product Support OR your local Ford
or Deutz dealer.
4-2 Engi ne Fault C odes
4-2
Engine Fault Codes
Ford MSG-425 and Deutz D 2.9 L4 Models:
Refer to Fault Codes Section for your specific
model of engine. Use the Fault Code Charts to aid
in identifying the fault.
46
4-3 Fl ex Plate
4-3
Flex Plate
The flex plate acts as a coupler between the engine
and the pump. It is bolted to the engine flywheel
and has a splined center to drive the pump.
1 pump
2 pump shaft
3 coupler
4 flex plate
5 flywheel
6 7/16 inch / 11 mm gap - Deutz models
0.080 inch / 2 mm gap - Ford models
How to R emove the Flex Pl ate - F ord M odels
How to Remove the Flex Plate -
Ford Models
1
Release the latches on the engine tray and
fully slide the engine tray out.
2
Insert a 6 inch / 15 cm screwdriver or rod into
the engine tray lock hole located near the
engine tray roller wheels to prevent the engine
tray from moving.
3
Tag and disconnect the exhaust gas sensor in
the exhaust pipe adjacent to the engine
exhaust manifold.
GS-84 • GS-90
September 2016
Part No. 1272222