How To Adjust The Platform Lower Speed - Genie GS-3384 Service And Repair Manual

Service and Repair Manual
Ground Controls
How to Adj ust the Pl atform Low er Speed
How to Adjust the Platform Lower
Speed
1 Pull out the red Emergency Stop button to the
on position at the platform controls.
2 Push in the red Emergency Stop button to the
off position at the ground controls.
3 Turn the key switch to ground control.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at
the ground controls.
Result: TUNE SPEEDS is showing in the
diagnostic display window. The ECM is now in
programming mode.
5 Press the lift function enable button.
6 Use the yellow platform down arrow to scroll to
descent speed.
Result: MAX DESCENT SPEED is showing in
the diagnostic display window.
1 diagnostic display
2 blue platform up button
3 lift function enable button
4 yellow platform down button
56
7 Press the lift function enable button.
8 Press the yellow platform down button to
decrease the platform descent speed or press
the blue platform up button to increase the
platform descent speed. Refer to
Specifications, Performance Specifications.
Note: The performance achieved should always be
within specifications.
9 Press the lift function enable button.
10 Push in the red Emergency Stop button to the
off position at the ground controls.
11 Check the lower speed of the machine. Refer
to Specifications, Performance Specifications.
GS-84 • GS-90
September 2016
Part No. 1272222