Genie GS-3384 Service And Repair Manual page 57

September 2016
7 Attach a lifting strap from an overhead crane
or similar lifting device to the lifting eye at the
rod end of the lift cylinder for support.
upper cylinder
lower cylinder
1 rod end
2 lifting eye
3 barrel end
8 Attach a lifting strap from a second overhead
crane or similar lifting device to the lifting eye
at the barrel end of the lift cylinder for support.
Part No. 1272222
Scissor Components
9 Remove the lift cylinder rod-end pivot pin
retaining fastener. Use a soft metal drift to
remove the pin.
10 Carefully lower the cylinder to a horizontal
position. Protect the cylinder rod from
damage.
11 Remove the lift cylinder barrel-end pivot pin
retaining fastener. Use a soft metal drift to
remove the pin.
Note: Use of the overhead crane may be required
for the pin to clear the link set.
12 Carefully pull the lift cylinder out the non-steer
end of the machine through the scissor arms.
Remove the lift cylinder from the machine.
GS-84 • GS-90
Service and Repair Manual
Crushing hazard. The lift cylinder
will fall unless it is properly
supported.
Component damage hazard.
The counterbalance valve on the
lift cylinder can be damaged if it
is allowed to come in contact
with the scissor arm cross tube.
Crushing hazard. The lift cylinder
will fall unless it is properly
supported.
Crushing hazard. The lift cylinder
may become unbalanced and fall
when it is removed from the
machine if not properly
supported.
45