Genie GS-3384 Service And Repair Manual page 49

Scissor lift
Hide thumbs Also See for GS-3384:
Table of Contents

Advertisement

September 2016
61 Place a rod through the cable tray pivot pin
and twist to remove the pin. Lower the cable
tray onto the number 1 inner arm (index #14).
Crushing hazard. The cable tray
may fall if not properly supported
by the overhead crane.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
62 Secure both ends of the number 2 inner and
outer arms (index #26 and #27) together with
a strap or other suitable device.
63 Attach a lifting strap from an overhead crane
to the number 2 inner and outer arms (index
#26 and #27) at the steer end of the machine.
Do not apply any lifting pressure.
64 Attach a lifting strap from an overhead crane
to the number 2 inner and outer arms (index
#26 and #27) at the non-steer end of the
machine. Do not apply any lifting pressure.
65 Remove the pin retaining fasteners from both
number 2 pivot pins (index #13) at the
non-steer end of the machine. Do not remove
the pins.
66 Remove the pin retaining fasteners from both
number 2 pivot pins (index #28) at the steer
end of the machine. Do not remove the pins.
Part No. 1272222
Scissor Components
67 Use a slide hammer to remove both number
2 pivot pins (index #13) from the non-steer
end of the machine.
68 Use a slide hammer to remove both number
2 pivot pins (index #28) from the steer end of
the machine.
69 Carefully remove the number 2 inner and
outer arms (index #26 and #27) from the
machine.
Note: If further disassembly of the scissor arm pair
is required, refer to Repair Procedure, How to
Disassemble a Scissor Arm Pair.
70 Remove the cables from the number 1 inner
arm (index #14).
71 Secure both ends of the number 1 inner and
outer arms (index #14 and #16) together with
a strap or other suitable device.
72 Attach a lifting strap from an overhead crane
to the number 1 inner and outer arms (index
#14 and #16) at the steer end of the machine.
Do not apply any lifting pressure.
73 Attach a lifting strap from an overhead crane
to the number 1 inner and outer arms (index
#14 and #16) at the non-steer end of the
machine. Do not apply any lifting pressure.
74 Remove the pin retaining fasteners from both
chassis centering link pivot pins (index #30) at
the number 1 inner arm.
GS-84 • GS-90
Service and Repair Manual
Crushing hazard. The number
2 inner and outer arms could
become unbalanced and fall
when they are removed from the
machine if not properly
supported by the overhead
crane.
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gs-3390Gs-4390Gs-5390

Table of Contents