Genie GS-3384 Service And Repair Manual page 41

September 2016
46 Remove the strap installed in step 32.
47 Support the cable tray with an overhead
crane.
48 Remove the pin retaining fasteners from the
cable tray pivot pin at the cross tube of the
number 2 inner arm (index #8).
49 Place a rod through the cable tray pivot pin
and twist to remove the pin. Lower the cable
tray onto the number 1 inner arm (index #10).
Crushing hazard. The cable tray
may fall if not properly supported
by the overhead crane.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
50 Secure both ends of the number 2 inner and
outer arms (index #8 and #20) together with a
strap or other suitable device.
51 Attach a lifting strap from an overhead crane
to the number 2 inner and outer arms (index
#8 and #20) at the steer end of the machine.
Do not apply any lifting pressure.
52 Attach a lifting strap from an overhead crane
to the number 2 inner and outer arms (index
#8 and #20) at the non-steer end of the
machine. Do not apply any lifting pressure.
Part No. 1272222
Scissor Components
53 Remove the pin retaining fasteners from both
number 2 pivot pins (index #9) at the
non-steer end of the machine. Do not remove
the pins.
54 Remove the pin retaining fasteners from both
number 2 pivot pins (index #21) at the steer
end of the machine. Do not remove the pins.
55 Use a slide hammer to remove both number
2 pivot pins (index #9) from the non-steer end
of the machine.
56 Use a slide hammer to remove both number
2 pivot pins (index #21) from the steer end of
the machine.
57 Carefully remove the number 2 inner and
outer arms (index #8 and #20) from the
machine.
Note: If further disassembly of the scissor arm pair
is required, refer to Repair Procedure, How to
Disassemble a Scissor Arm Pair.
58 Remove the cables from the number 1 inner
arm (index #10).
59 Secure both ends of the number 1 inner and
outer arms (index #10 and #12) together with
a strap or other suitable device.
60 Attach a lifting strap from an overhead crane
to the number 1 inner and outer arms (index
#10 and #12) at the steer end of the machine.
Do not apply any lifting pressure.
GS-84 • GS-90
Service and Repair Manual
Crushing hazard. The number
2 inner and outer arms could
become unbalanced and fall
when they are removed from the
machine if not properly
supported by the overhead
crane.
29